Micro motorreductor Alto torque carbón HPCB 1000:1 32-RPM. Este micro motor con engranes viene para trabajar con un rango de voltajes de 3 a 9V. Las 32 RPMs las da a los 6V. El motorreductor es compatible con tornillos M1.6 de 1.6mm de diametro. Tambien puedes utilizar un soporte lateral que tenemos aqui en HeTPro, tambien en nuestra tienda virtual. Este motorreductor es ideal para proyectos de robotica, siguelineas, sumo. El motorreductor tienen una longitud de 9.27mm. Eje tipo D de 3 mm.
- Marca: Solarbotics.
- Velocidad: 32RPMs.
- Voltaje: 6V (3V a 9V).
- Corriente de paro: 1600mA.
- Torque de paro: 125 oz-in.
- Longitud de 9.27mm.
- Eje tipo D de 3 mm.
These tiny brushed DC gearmotors are intended for use at 6 V, though in general, these kinds of motors can run at voltages above and below this nominal voltage, so they should comfortably operate in the 3 – 9 V range (rotation can start at voltages as low as 0.5 V). Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor. The micro metal gearmotors are available in a wide range of gear ratios—from 5:1 up to 1000:1—and with four different motors: high-power with long-life carbon brushes (HPCB), high-power with shorter-life precious metal brushes (HP), medium-power (MP), and low-power. The HPCB version (shown on the left in the picture below) can be differentiated from versions with precious metal brushes (shown on the right) by its copper-colored terminals and slightly less shiny case. Note that the HPCB terminals are 0.5 mm wider than those on the other micro metal gearmotor versions (2 mm vs. 1.5 mm), and they are about 1 mm closer together (6 mm vs. 7 mm).
With the exception of the 1000:1 gear ratio versions, all of the micro metal gearmotors have the same physical dimensions, so one version can be easily swapped for another if your design requirements change. Please see the micro metal gearmotor comparison table for detailed specifications of all our micro metal gearmotors. This dynamically-sortable table can help you find the gearmotor that offers the best blend of speed, torque, and current-draw for your particular application. A more basic comparison table is available below.
Some versions of the gearmotors are available with an additional 1 mm-diameter output shaft that protrudes from the rear of the motor. This 4.5 mm-long rear shaft rotates at the same speed as the input to the gearbox and offers a way to add an encoder, such as our magnetic encoder for micro metal gearmotors (see the picture on the right), to provide motor speed